Edit menu

Return to Introduction  Previous page  Next page

ide_menu_edit

Edit Menu

 

Undo (Shortcut: CTRL+Z)

The Undo command restores the schematic to the state before the last action you performed. The Undo queue is five operations deep.

 

Redo (Shortcut: CTRL+Y)

The Redo command restores the schematic to the state before the last Undo action you performed.

 

Cut ( Shortcut: Ctrl+X )

With the Cut command you can move in the global clipboard a single object or a group of objects from the schematic. To move a single object select the object pressing the left button of the mouse when you are above the object then perform a Cut command. To move a group of object first select the objects with the select tool then use the Cut command.

 

Copy ( Shortcut: Crtl+C )

The Copy command allows you  to copy a single object or a group of objects in the private clipboard. To copy a single object first select the object pressing the left button of the mouse when you are above the object then perform a Copy Command. To copy a group of object first select the objects wih the select tool then use the Copy command.

 

Paste (Shortcut: Ctrl+V)

The Paste command pastes a single object  or a group of objects in the worksheet previously copied with the Copy command

 

Delete (Shortcut: Canc/Del)

The Delete command has the same behaviour of the Cut command

 

Find (Shortcut: Shift+F3)

This command allow you to find occurrences of a particular strings in the items present in the diagram. The search results are shown in the Find tab of the message window. This command is often used to search a particular REFERENCE identifier to locate a component in the schematic.

 

Find Next (Shortcut: F3)

This command can be issued after a previous Find command allowing you to move on the next occurrence which honour the established conditions.

 

Notes (Shortcut: Ctrl+R)

This command allow you to enter project notes.