View menu

Return to Introduction  Previous page  Next page

View menu allow to enable or disable some elements present in the IDE and in the sheet where you draw the design.

 

ide_menu_view

View menu

 

Toolbar

This menu entry opens the following sub-menu.

 

ide_menu_view_toolbar

Toolbar sub-menu

 

Standard

This command enables/hides the Windows standard tool bar. The standard toolbar is the bar where you can find the traditional windows commands like new, load, save and so on.

 

Tools

This menu entry enables/hides the tool bar window. The tool bar is the window where you can find the tools for placing components, wires, text and bitmaps. In this bar you can also find the commands for change zoom factors in the current view.

 

Compile

Checking/Unchecking  this entry will enable/disable the compile bar window. The compile bar contains the command to build the code and other commands for PLC controlling like upload, run and stop.

 

Components

Checking/Unchecking  this entry will enable/disable the components/library bar window. This window contains  the components that you can place in the schematic.

 

Status Bar

This menu entry allow you to show or hide the IDE's status bar

 

Grid

The grid check enables/hides the grid in the worksheet.

 

Reference Grid

Checking/Unchecking  this entry will enable/disable the reference grid in the worksheet .

 

Watch Sections (Shortcut: F4)

If your software version handles the variable watching this menu allow you to enter the Watch Sections Dialog.